Iβve been asked to share the finished drawing of Eeyore so here he is π
Comments
Barbara I think you should be fine with the pad - itβs just a little tougher than the board is all - just use light pressure even if you think itβs not working - thereβs always an element of omg when using pastelmat π
Bonny Snowdon
2019-03-19 07:01:38 +0000 UTC
Bonny Ism getting off to a rather slow start...just got my initial sketch put on my Pastelmat but I have the tougher surface thatβs on the pastelmat pad. Do you think this will be too rough to get the details? I have some UArt 800 I could resketch him on. I had to order a Slice ceramic as everything I can find here is X-Acto metal blades and I thought that would cut through the paper. Thank you, hope classes are going good!